Directions for Putting in a Wall Water Fountain

Make any room better with a wall fountain. The benefits of the water sounds include providing tranquility and calm to the room. While any room will benefit from a wall fountain, they are most often placed in entryways. Although the instructions for putting one up are fairly straightforward there will be slight modifications depending on the model. ft-153__41068.jpg Bear in mind that different components will need to be put together during assembly. You will need to connect the pump and tubing, and the base will need to be connected to the top portion. Remember to review the directions before getting started in order to avert mistakes. You should find the procedure relatively simple. That said, there can be small differences depending on which style you have. Have a colleague hold the wall fountain in the desired place, then mark the wall as necessary. To make sure it will be straight, get a level. Both the upper end and the bottom should be marked. There is more than one method to install a wall fountain. The first is to use screws which you slide directly into the slots on the back. A second option is use brackets mounted on the wall. The bracket alternative is best, specifically for wall fountains that are big and bulky. Mark the spot on the wall where the brackets need to be attached. Drill pilot holes in the wall for the drywall anchors. Insert the anchors by attentively hammering them into the wall. Hold the brackets in position on the wall and use a cordless drill or screwdriver to affix them. Now, lift your unit and place it on the mounting brackets. Check to see that it is in the proper position and secure on the brackets. Water can be added as soon as the fountain has been positioned.

Make certain there is enough water to cover the pump. At this point plug it in and the water will start to flow. The water basin should be filled to around one inch below the top edge. The basin will overflow when the pump is shut off if it’s too full, so be careful not to fill it completely. The water level will rise because it all settles at the bottom of the basin if not getting pumped. When the fountain is too full, water can spill out and cause damage to the nearby area.

Factors to Think About When Determining Where to Put Your Water Feature

One of the first things to consider when selecting a water fountain is exactly where you plan to put it. Roundabouts and drives are ideal spots for them.

It is also possible to acquire a fountain made especially to be mounted against a wall. Typically, they have something on the back of them like a hook or a bar with which you can use to affix them to a wall, post, or some other secure spot. There are many natural hazards such as wind or animals which can knock over your fountain if you do not securely affix it to the wall, so do not neglect to do this as soon as possible.

A popular place to add a garden sculpture is commonly in areas where people come together to sit back and enjoy the scenery.

An Absolute Roman Masterpiece: The Santa Maria Water Fountain in Cosmedin

Archaeologists and restorers on the lookout for pagan and Christian relics in Rome have come upon a treasure trove of them in the area of the Santa Maria in Cosmedin. The celebrated marble sculpture called the Bocca della Verità (Mouth of Truth) can be seen in the portico of the basilica nearby. The location of the Santa Maria in Cosmedin fountain (1719) was not in a well-known neighborhood and was, therefore, not oftentimes visited. The part of town where it was situated was forlorn and uninviting which generally kept people away. As part of an effort to modernize the square outside the church of Santa Maria in Cosmedin, the Italian architect Carlo Bizzaccheri was instructed by Pope Clement XI to design a fountain. August 11, 1717 saw the beginning of the task to put down the foundation of the church. After blessing of the first stone, medallions bearing the illustration of the Blessed Virgin, for whom the church is named, and of St. John the Baptist, the patron saint of water, were tossed into the foundation.

Gardens of Chatworth and its Revelation Water Feature

Designed by well-known English sculptor Angela Conner, "Revelation" is the newest addition to the Chatsworth ornamental outdoor water features. In 2004/2005 she was commissioned by the late 11th Duke of Devonshire to create a limited edition bust of Queen Elizabeth, in brass and steel, for the Queen’s 80th birthday. “Revelation” was put up in 1999 in Jack Pond, one of Chatsworth’s first ponds. The four large metallic petals open and close with the movement of water, alternatively camouflaging and revealing a gold colored globe at the sculpture’s heart. Standing five meters high and five meters wide, the globe was crafted from steel and then coated with gold dust. This latest water fountain is an intriguing addition to the Gardens at Chatsworth because the petals’ movement is completely powered by water.

Modern Garden Decoration: Garden Fountains and their Roots

A water fountain is an architectural piece that pours water into a basin or jets it high into the air in order to supply drinking water, as well as for decorative purposes.

The main purpose of a fountain was originally strictly practical. Cities, towns and villages made use of nearby aqueducts or springs to supply them with drinking water as well as water where they could bathe or wash. Until the late nineteenth, century most water fountains functioned using the force of gravity to allow water to flow or jet into the air, therefore, they needed a source of water such as a reservoir or aqueduct located higher than the fountain. Serving as an element of decoration and celebration, fountains also supplied clean, fresh drinking water. The main components used by the Romans to create their fountains were bronze or stone masks, mostly illustrating animals or heroes. During the Middle Ages, Muslim and Moorish garden planners incorporated fountains to create smaller depictions of the gardens of paradise. Fountains enjoyed a considerable role in the Gardens of Versailles, all part of French King Louis XIV’s desire to exert his power over nature. To mark the entrance of the restored Roman aqueducts, the Popes of the 17th and 18th centuries commissioned the building of baroque style fountains in the spot where the aqueducts entered the city of Rome

Since indoor plumbing became the standard of the day for fresh, drinking water, by the end of the 19th century urban fountains were no longer needed for this purpose and they became purely ornamental. Fountains using mechanical pumps instead of gravity allowed fountains to provide recycled water into living spaces as well as create special water effects.

Beautifying city parks, honoring people or events and entertaining, are some of the uses of modern-day fountains.

Did You Know How Mechanical Designs And Styles of Water Fountains Became Known?

Throughout the European countries, the chief means of dissiminating practical hydraulic facts and fountain design suggestions were the published papers and illustrated books of the day, which contributed to the development of scientific innovation. An un-named French water fountain engineer was an internationally famed hydraulic leader in the later part of the 1500's. With Royal commissions in Brussels, London and Germany, he started his work in Italy, acquiring experience in garden design and grottoes with integrated and imaginative water hydraulics.

In France, towards the closure of his lifetime, he wrote “The Principle of Moving Forces”, a book which turned into the fundamental text on hydraulic mechanics and engineering. Replacing vital hydraulic findings of classical antiquity, the book also explains contemporary hydraulic technologies. Archimedes, the inventor of the water screw, had his work featured and these integrated a mechanical way to move water. Sunlight heating water in a couple of vessels hidden in a room adjacent to an decorative water fountain was displayed in one illustration. The hot liquid expands and subsequently rises and closes the pipes consequently activating the water fountain. Models for pumps, water wheels, water attributes and garden ponds are also included in the book.

Agrippa’s Splendid Water-lifting Machine

The praise Agrippa’s water-lifting creation received from Andrea Bacci in 1588 was short-lived. It may be that the Acqua Felice, the second of Rome’s early modern aqueducts made the device outdated when it was connected to the Villa Medici in 1592. The simpler explanation is that it was disregarded about when Ferdinando left for Florence in 1588, after the passing of his brother Francesco di Medici, to trade his rank as cardinal for one as the Grand Duke of Tuscany. #P# It could defy the force of gravity to lift water to Renaissance gardens, supplying them in a way other late 16th century concepts like scenographic water presentations, musical fountains and giochi d’acqua or water caprices, were not.


Contemporary Garden Decor: Fountains and their Beginnings
Modern-day fountains function mostly as decoration for public spaces, to honor individuals or events, and compliment entertainment and recreational gatherings. read more
The Results of the Norman Conquest on Anglo-Saxon Garden Design
The Anglo-Saxon way of life was significantly changed by the introduction of the Normans in the later eleventh century. At the time of the conquest, the Normans surpassed the... read more
The One Cleaning Solution to NEVER Use On Your Garden Wall Fountains
Finally, be sure to have a quick look at your fountain every day and add water if you see that the level is depleted. Permitting the water level to get too low can result in damage to the pump - and you certainly don't want... read more
Delight in the Unique Design of the Cascade Water Fountain at Chatsworth
At the back of Chatsworth House, the Cascade garden fountain forms a dazzling focal point to the landscape. Extending down the hillside for 200 yards in the direction of the residence is a group of 24 irregularly ... read more